Printed from www.nzmeccano.com
Login status: You have not yet entered your user name and password. You cannot upload photographs until you do.
Item 5 of 18
3 simulated hydraulic rams used.
I quote from CQ:
"For the rams, I opted for 6 mm threaded rods, with the end 1.1/4" turned down to 4.1 mm.
These screw into 8 mm stainless steel tubes, originally 5 mm inside diam, but bored out to 6.1 mm, except the end 1/2", which is threaded 6 mm......
The tube slides in a 5/16 Exacto coupling, fitted inside an MW long sleeve piece."
Image by Joe Attard, viewed 1242 times.
Size: 285.48kb (1950x805 pixels) 
Log in to the gallery
If you have any interesting information or comments about this page, please add them here: